Logo

B1192 Engine Code Repair

Meaning of B1192 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B1192 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for B1192 code is occuring now you should check B1192 repair processes.
Now don't ask yourself; What should you do with B1192 code ?
The solution is here :

B1192 Possible Solution:

B1192 Engine

The firing order is an important part of the overall design of the engine and is determined during the design of the engine to eliminate as much engine vibration as possible. If the firing order is changed or adjusted, the ignition from the spark plug is delivered at the wrong time and the engine functions poorly or does not run. The firing order for a particular engine is typically found in the repair manual specific to that model.

B1192 Code Meaning :

B 1 1 9 2
OBD-II Diagnostic Body (B) Trouble Code For Engine Fuel And Air Metering Ambient Air Temperature Sensor Circuit Low Ignition/Distributor Engine Speed Input Circuit Malfunction Crankshaft Position Sensor A Circuit Low Input

Regarding the B1192 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

B1192 OBD-II Diagnostic Body (B) Trouble Code Description

B1192 engine trouble code is about Crankshaft Position Sensor A Circuit Low Input.

Main reason For B1192 Code

The reason of B1192 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low.

B1192 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.